Step 5: Barrel (Con't)

Are you still thinking about how it's going to fire? If no then you’re safe, if yes you may already be fired.

Place a hook connector made out of acrylic on the top of the front barrel section.

Spray the plastic barrel with plastic primer then normal primer to get a uniformed finish and sand down lumps and uneven sections.

Do the same with the front and rear shells. If there are any uneven sections or dents in the parts fill and sand again until you get to the finish you want.

Test fit the barrel in the two shells to make sure it all fits together.

Cut out and construct the claws out of acrylic.